SpaceX is gearing up to launch another batch of Starlink satellites to low Earth orbit (LEO). Liftoff is scheduled to occur at 10:50 AM EDT (14:50 UTC) on Oct. 20 from Space Launch Complex 40 (SLC-40) at Cape Canaveral Space Force Station in Florida.
This mission–known as Group 4-36–will see Falcon 9 loft 54 Starlink satellites to the fourth shell of SpaceX’s Starlink constellation, bringing the total number of Starlink satellites launched to over 3,500.
Nine minutes later, the engine chill process will begin. In this process, a small amount of liquid oxygen is allowed to flow through the turbopumps of each of the nine Merlin 1D engines on the first stage. This thermally conditions the pumps ahead of the high flow of this cryogenic fluid during engine ignition and avoids the creation of bubbles of oxygen that could damage the pumps.
At the T-6 minute mark, RP-1 load will finish on the first stage and the tanks will get ready for pressurization ahead of strongback retraction. The strongback retraction process will begin at around T-4 minutes with the opening of the top clamp arms followed by a roughly one-and-a-half-degree rotation away from the rocket.
LOX load will end on the first stage at around T-3 minutes and will continue on the second stage until approximately T-1 minute and 40 seconds. Once propellant loading is complete, the rocket and ground systems will prepare for liftoff. This includes purging the propellant lines to both the booster and second stage as well as performing final software checks.
At T-1 minute, control of the automated countdown sequence will be handed over to Falcon 9’s onboard computers in a process SpaceX calls “startup.” At this point in the sequence, the tanks will also start to pressurize to flight levels. Shortly after, the launch director will then give the go or no-go decision to proceed with the launch.
At T-3 seconds, the onboard computers will command ignition of all nine Merlin 1D engines on the first stage, which will ramp up to full power 2.8 seconds later. If engine health is confirmed to be good, the rocket will command the ground computers to release the hold-down clamps, allowing the vehicle to lift off.
The flight profile for this mission follows a similar one to all recent Starlink missions to shell four from Cape Canaveral, where the vehicle arches to the northeast over the Atlantic Ocean. The rocket will pass through the area of maximum aerodynamic pressure–or max-Q–roughly one minute and 10 seconds into flight.
Roughly two and a half minutes into the flight, Falcon 9’s first-stage engines will shut down in an event called main engine cutoff–or MECO. A few seconds after this, both stages will separate and the second stage will ignite its single Merlin 1D Vacuum (MVacD) engine.
This will be MVacD’s first of two burns during the mission and will last approximately six minutes. Shortly after ignition, the payload fairing halves will separate. While the second stage and Starlink satellites continue on their flight to the target 232-by-336 kilometer orbit, the first stage and fairing halves will return to Earth for recovery and reuse.
The first stage will execute its traditional entry and landing burns, targeting a touchdown on SpaceX’s Autonomous Spaceport Drone Ship A Shortfall Of Gravitas (ASOG).
The fairing halves, meanwhile, will orient themselves for reentry using cold gas thrusters and then parachute down to a soft splashdown on the ocean. These will be recovered by SpaceX’s multi-purpose recovery vessel Doug.
Both recoveries will occur more than 650 km downrange in the North Atlantic Ocean.
Once both the second stage and Starlink satellites have reached orbit, the second stage will initiate an end-over-end rotation maneuver. This will aid in the dispersion of the satellites after deployment, which should happen at around T+15 minutes.
Once the satellites are deployed, the MVacD engine on the second stage will perform another burn for deorbit and disposal over the Pacific Ocean. Elon Musk recently shared a video on Twitter of this process as captured by one of the satellite’s onboard engineering cameras on a prior mission.
Thursday’s launch is aiming to put 54 more Starlink satellites into the fourth shell of the first generation of the constellation, bringing the total of Starlink satellites launched to 3,505. Out of these, 275 satellites have already reentered. Of the ones remaining in orbit, 63 are non-maneuvering and 2,704 are in their operational orbit.
Falcon 9’s first stage for this mission, B1062, will be flying for the 10th time after previously supporting the launch of two GPS-III satellites, two private Crew Dragon missions, the launch of the Nilesat 301 geostationary satellite, as well as four prior Starlink missions. This will put 1062 as the sixth booster in the fleet to reach SpaceX’s initial goal of flying the first stages 10 times with minimal refurbishment between flights.
SpaceX’s launch on Thursday will be the 63rd launch dedicated to Starlink and the company’s fifth launch of the month. Another Starlink mission from the Cape was previously scheduled to launch next week; however, this was delayed into November to prioritize maintenance work at the launch pad, as well as to ensure schedule priority for commercial customers.
SpaceX’s next mission from Florida will therefore be the long-awaited launch of the USSF-44 mission onboard a Falcon Heavy rocket, currently scheduled for no earlier than Oct. 31. Work has been underway at Launch Complex 39A for the past two weeks to prepare the ground systems for the fourth launch of the world’s most powerful operational rocket.
Source: https://www.nasaspaceflight.com/2022/10/spacex-3500-starlink/